采矿与安全工程学报 ›› 2013, Vol. 30 ›› Issue (4): 506-511.

• 论文 • 上一篇    下一篇

近距离厚煤层组工作面覆岩破坏规律实测研究

  

  1. 中国矿业大学(北京)资源与安全工程学院,北京 100083
  • 出版日期:2013-07-15 发布日期:2013-07-09
  • 作者简介:许延春(1963-),男,河北省乐亭县人,博士生导师,研究员,从事近水体安全采煤方面的研究。 E-mail:yanchun-xu@163.com Tel:13681272776
  • 基金资助:

    国家重点基础研究发展计划(973)项目(2013CB227903)

Overburden failure laws in working face of short distance thick coal seams group

  • Online:2013-07-15 Published:2013-07-09

摘要: 为深入研究近距离厚煤层组综放开采覆岩破坏规律,并为合理留设露头区安全煤(岩)柱提供数据依据,指导浅部工作面防治溃水、溃砂等水害事故,以大屯矿区7,8煤近距离厚煤层组工作面为例,在前期上层煤(7煤)覆岩破坏规律观测研究的基础上,近期采用井下“两带”观测仪观测了下层煤(8煤)的“两带”高度发育特征,从而在我国率先全面实测了近距离厚煤层组工作面覆岩破坏规律。结果表明:上层煤的底板破坏范围与下层煤垮落带发育范围有重合区域时,下层煤垮落带高度增大;下层煤综放开采按综合采厚计算的裂采比与以往单一煤层的裂采比较为接近,但按下层煤采厚计算的裂采比高于综放开采单一煤层的裂采比52%。“三下采煤规程”中的“两带”高度预计公式在近距离厚煤层组综放开采条件下应当进一步完善。

关键词: 近距离厚煤层组;&ldquo, 两带&rdquo, 高度;煤(岩)柱

Abstract: In this paper, to deeply study the overburden failure rules in sub-level caving mining of close distance thick coal seams group, and provide basis for the reasonable setting of safety coal and rock pillars in the outcrop area to control the water disasters (e.g.water inrush, sand inrush) occurred in shallow part coal face, taking one working face in close distance thick coal seams group (No.7 and No.8 Coal Seams) of Datun Mining Group as example, on the basis of early observation of overlying strata failure rules in the upper coal seam (No.7 Coal Seam), the underground “two zones” visualizer was recently used to observe the “two zones” height development characteristics of the lower coal seam (No.8 Coal Seam), thus taking the leading and comprehensive measurement of overburden failure laws in the working face of close distance thick coal seams group in China. The results show that when there exits coincidence area between the floor damage range of the upper coal seam and the caving zone development range of the lower coal seam,the caving zone height of the lower coal seam will increase.Meanwhile, the ratio of the fractured zone height to the mining height in sub-level caving mining of close distance thick coal seams group is similar to that in the one single coal seam according to the calculation of comprehensive mining thickness, while the ratio is higher than that in one single seam about 52% according to the calculation of lower coal seam thickness. Therefore, the calculation formula of “two zones” height in “Mine regulations in three special conditions” needs further improvement under the conditions of sub-level caving mining in the close distance thick coal seams group.

Key words: close distance thick coal seams group, “two zones&rdquo, height;coal and rock pillar close distance thick coal seams group, “two zones&rdquo, height;coal and rock pillar