大倾角厚煤层综放工作面放煤工艺及顶煤运动特征试验

采矿与安全工程学报 ›› 2016, Vol. 33 ›› Issue (2): 208-213.

大倾角厚煤层综放工作面放煤工艺及顶煤运动特征试验

1．北京科技大学土木与环境工程学院，北京 100083； 2．河北工程大学资源学院，河北邯郸 056038； 3．邢台学院，河北邢台 054001；4．大阳煤矿分公司，山西晋城 048003

收稿日期:2015-01-31 出版日期:2016-03-15 发布日期:2016-04-22
作者简介:孙利辉(1978—)，男，辽宁省清原县人，讲师，博士，从事矿山压力及岩层控制方面的研究。
基金资助:
国家自然科学基金重点项目(51534002)；国家自然科学基金项目(51174015，51174070)

Top-coal caving process and movement characters of fully mechanized caving face in steeply dipping thick seam

Received:2015-01-31 Online:2016-03-15 Published:2016-04-22

摘要/Abstract

摘要： 为研究大倾角工作面放煤工艺及顶煤运动特征，采用相似材料模拟，依据放煤步距、放煤顺序、放煤方式、煤层倾角的不同构建了 15 种放煤模型，对比分析了不同放煤条件下对回采率、顶煤与矸石运动规律的影响。结果表明：工作面倾向采用由下向上单轮顺序放煤、回采方向采用一采一放的组合方式放煤，工作面回采率最高；随着煤层倾角增大，回采率逐渐降低。受煤层倾角影响，放煤漏斗呈非对称圆锥形，由上向下放煤漏斗为倒圆锥，由下向上放煤漏斗为正圆锥；而放煤漏斗轮廓受煤层倾角影响不大。由上向下放煤顶煤有滞留现象，而由下向上放煤则无顶煤滞留现象，下端头可尽可能多放煤，上端头要控制放煤。

关键词: 大倾角, 放顶煤工作面, 放煤工艺, 煤矸运动

Abstract: To analyze the top-coal caving process and movement characters in steeply dipping thick coal seam face, similar simulations were conducted and fifteen models were constructed according to different top-coal caving interval, top-coal caving sequence, caving methods and dipping, and the influence on recovery ratio and movement law of top-coal and gangue under different caving conditions was comparatively analyzed. The results show that：The combination mode of single sequence top-coal caving from lower to upper in dip direction and one-mining one-caving in the mining direction has the highest recovery ratio, and the recovery ration decreases with coal seam dip increasing. The caving is an non symmetrical cone due to the influence of coal seam dip, a turbination funnel type is presented when caving from upper to lower, whereas a positive conical funnel type is presented when caving from lower to upper. The coal seam dip angle has little effect on the caving funnel. The top-coal retention phenomenon of caving appears from upper to lower, but not appears from lower to upper, thus the lower-end should be caving as much as possible whereas the caving should be controlled on upper-end.

Key words: steeply dipping, top-coal caving face, coal caving process, movement of coal and gangue

孙利辉，纪洪广，蔡振禹，张标，杨本生. 大倾角厚煤层综放工作面放煤工艺及顶煤运动特征试验[J]. 采矿与安全工程学报, 2016, 33(2): 208-213.

SUN Lihui，JI Hongguang，CAI Zhenyu，ZHANG Biao，YANG Bensheng. Top-coal caving process and movement characters of fully mechanized caving face in steeply dipping thick seam[J]. Journal of Mining & Safety Engineering, 2016, 33(2): 208-213.

[1]	解盘石，伍永平，罗生虎，王红伟，郎丁. 大倾角大采高采场倾向梯阶结构演化及稳定性分析[J]. 采矿与安全工程学报, 2018, 35(5): 953-959.
[2]	王红伟，伍永平，解盘石，罗生虎，刘孔智，刘茂福. 大倾角煤层长壁大采高工作面煤壁稳定性的采厚效应[J]. 采矿与安全工程学报, 2018, 35(1): 64-70.
[3]	张宇宁，唐建新，陈宇龙，李国栋. 大倾角煤层柔性护巷特性及应用研究[J]. 采矿与安全工程学报, 2017, 34(3): 542-548.
[4]	王旭锋，汪洋，张东升. 大倾角“三软”煤层巷道关键部位强化支护技术研究[J]. 采矿与安全工程学报, 2017, 34(2): 208-213.
[5]	王红伟，伍永平，解盘石，李延军. 大倾角煤层开采“关键域”岩体结构稳定性分析[J]. 采矿与安全工程学报, 2017, 34(2): 287-294.
[6]	时成忠，刘长友，李建伟，黄斌. 综放面端头设备交叉侧卸布置及放煤工艺研究[J]. 采矿与安全工程学报, 2017, 34(1): 79-84.
[7]	高喜才，伍永平，曹沛沛，王红伟，尹建辉. 大倾角煤层变角度综放工作面开采覆岩运移规律[J]. 采矿与安全工程学报, 2016, 33(3): 381-386.
[8]	范明建，康红普，林健，任勇杰，赵鹏，张辉，赵光雷. 埋深 1300 m 大倾角复合岩层巷道围岩综合控制技术研究[J]. 采矿与安全工程学报, 2015, 32(5): 706-713.
[9]	张平松，凡净，吴荣新，郭立全. 大倾角煤层工作面底板岩层富水异常区探查方法研究[J]. 采矿与安全工程学报, 2015, 32(4): 639-643.
[10]	杨科, 陆伟, 潘桂如, 孙力. 复杂条件大倾角大采高旋转综采矿压显现规律及其控制[J]. 采矿与安全工程学报, 2015, 32(2): 199-205.
[11]	解盘石，伍永平，王红伟，任世广. 大倾角煤层大采高综采围岩运移与支架相互作用规律[J]. 采矿与安全工程学报, 2015, 32(1): 14-19.
[12]	吴锋锋, 刘长友, 李建伟. “三软”大倾角厚煤层工作面组合液压支架稳定性分析[J]. 采矿与安全工程学报, 2014, 31(5): 721-725.
[13]	张东升, 吴鑫, 张炜, 范钢伟. 大倾角工作面特殊开采时期支架稳定性分析[J]. 采矿与安全工程学报, 2013, 30(3): 331-336.
[14]	谢生荣, 张守宝, 何富连, 肖殿才, 田春阳. 大倾角孤岛综采面支架—围岩稳定性控制研究[J]. 采矿与安全工程学报, 2013, 30(3): 343-347.
[15]	张益东, 张付涛, 季明, 高林生, 金志远, 程亮, 巫林平. 特厚煤层合理放煤工艺研究[J]. 采矿与安全工程学报, 2012, 29(6): 808-814.